CISCO test

Which of the following OSI layers offers reliable, connection-oriented data communication services?

application

presentation

session

*transport

network


Router interface Ethernet 0 has been assigned the IP address 10.172.192.168 255.255.255.240. What is the network IP address of this interface?














Examine the graphic with current configurations. The New York Offices of ABC Company recently upgraded the computers in the administrative office. Shortly after the upgrade, Host A in the clerical office failed and was replaced with one of the retired administrative office computers. However, the computer can not access the company network in the new location. What is the likely cause of this network access issue for Host A?

MAC address incorrectly entered

*default gateway incorrectly entered

subnet mask incorrectly entered

IP address incorrectly entered




Which of the following increases the potential for a collision to occur?

the use of an active hub instead of an intelligent hub

the use of an intelligent hub instead of an active hub

a reduction in the number of devic 17517c25r es attached to the hub

*an increase in the number of devic 17517c25r es attached to the hub *


What is attenuation?

opposition to the flow of current

measurement of electrical signals relative to time

*degradation of a signal as it travels along the medium

amount or volume of traffic that is flowing on the medium


Two peer hosts are running applications that exchange data using UDP. During the current session, a datagram fails to arrive at the destination. What is true concerning the retransmission of the datagram?

*Datagram retransmission occurs when the retransmission timer expires in the source host.

Datagram retransmission occurs when the retransmission timer expires in the destination host.

Datagram retransmission is controlled by the application layer protocol.

Datagram retransmission involves only the data with sequence numbers equal to or higher than the sequence number of the current datagram.


What is significant about the ping 127.0.0.1 command?

*It verifies the operation of the TCP/IP protocol stack on a host and is called an internal loopback test.

It verifies connection to the remote host with the IP address 127.0.0.1.

It verifies whether the router that connects the local network to other networks can be reached.

It verifies the route packets take between the local host and the host with the IP address 127.0.0.1.


Which LAN switching mode has the highest latency?

fast forward

fragment-free
latency forwarding
*store-and-forward


Which of the following application layer protocols use UDP segments? (Choose two.)

*DNS

FTP

Telnet

*TFTP

SMTP


Which cable specifications are indicated by 100BASE-T?

100-Mbps transmission speed, baseband signal, coaxial cable

100-Mbps transmission speed, broadband signal, twisted-pair cable

*100-Mbps transmission speed, baseband signal, twisted-pair cable

Equal to 10-Gbps transmission speed, baseband signal, twisted-pair cable


When is a crossover cable used in a network?

when connecting a host to the router console port

when connecting a host to a switch

*when connecting a host to a host

when connecting a switch to a router


Refer to the graphic. What must be configured on Host A to allow it communicate with the e-mail server? (Choose three.)

IP address *

subnet mask *

default gateway *

router name

switch name

NetBIOS name address


Which cable diagram displays the end to end pinout for a crossover cable used with Cisco devices?

Cable A

Cable B

*Cable C

Cable D


Which type of address is 192.168.17.134/29?

*host address

network address

broadcast address

multicast address


How many collision domains are shown in the diagram?

three

four

five

*six

seven

eight


When is a straight-through cable used in a network?

when connecting a router through the console port

when connecting one switch to another switch

*when connecting a host to a switch

when connecting a router to another router


How does network cable length affect attenuation?

Category 5 cable that is run in metal conduit has the highest attenuation in the shortest distance.

Shorter cable lengths have greater signal attenuation.

*Longer cable lengths have greater signal attenuation.

The length of the cable has no effect on signal attenuation.


Which of the following statements are correct about CSMA/CD? (Choose three.)

It is a media access method used in LANs. *

It is a media access method used in FDDI WANs.

When a device needs to transmit, it checks to see if the media is available. *

A device sends data without checking media availability because all devices have equal access. Multiple devices can successfully transmit simultaneously.

*Only one device can successfully transmit at a time.


Which of the following must be present for current to flow? (Choose three.)

*closed loop

bit-generating device

insulating material

*source of voltage

*load

switch


If Host A pings Host B through a newly installed switch with no entries in the MAC address table, which stations will receive the ping packet?

B only

A and B

B and switch

A, B, and switch

B, C, D, and switch *

A, B, C, D, and switch



Which devices shown in the graphic must have a MAC address?

only PC

only router

PC and router

PC, hub, and router

*PC, printer, and router


What kind of connection is represented in the graphic?

*console connection

Ethernet connection

ISDN connection

leased line connection


Which of the following is the decimal representation of the binary number 11010011?










Which type of cable is required to make a connection between a router console port and a PC COM port?

straight-through cable

crossover cable

*rollover cable

DB-9 cable

coaxial cable


Determine the number of useable networks and hosts for the IP address 192.168.50.0/27

4 networks / 62 hosts

6 networks / 64 hosts

32 networks / 8 hosts

*6 networks / 30 hosts

8 networks / 32 hosts

2 networks / 8 hosts


A network administrator is placing an older router back in to service. The administrator discovered that the IOS and configuration files need to be updated to meet the LAN specifications. Which application layer protocol is used to transfer the new configuration files into the router memory?

*SNMP

SMTP

HTTP

TFTP


Which of the following best describes Spanning Tree Protocol?

It enables a network to span across multiple physical segments.

*It enables a switch to eliminate switching loops.

It enables a switch to dynamically choose the best switch mode.

It enables a switch to perform as a router.


Which of the following subnet masks could be used when subnetting a Class B IP address? (Choose two.)














How is data encapsulated as it is moved down the OSI model?

data, segments, frames, packets, bits

data, packets, segments, frames, bits

*data, segments, packets, frames, bits

data, packets, frames, segments, bits


Which of the following describes latency?

the noise generated from outside a cable

the degradation of a signal as it travels along the media

the time required for a NIC to place a frame on the network media

*the delay between the time a frame leaves its source device and reaches its destination


Which of the following is the binary representation of the decimal number 111?










Which LAN switching mode begins switching after reading only the first 64 bytes of the frame?

fast forward

*fragment-free

latency forwarding

store-and-forward


When using Category 5 UTP cable, which RJ-45 pin pairs are used to exchange data between hosts on an Ethernet network?

1 and 2; 4 and 5

1 and 2; 3 and 6 *

3 and 6; 7 and 8

4 and 5; 7 and 8


Which of the following commands could be used on a Windows-based computer to view the current IP configuration of the system? (Choose two.)

configip

ifconfig

*ipconfig

*winipcfg

winipconfig


Which type of address is 192.168.17.111/28?

host address

network address

*broadcast address

multicast address


Which of the following networking devices increase the number of collision domains? (Choose three.)

*switch
hub
*router
repeater
*bridge


What information can be determined from the MAC addresses of PC1, PC2, and PC3, as shown in the graphic? (Choose two.)

PC1 and PC2 NICs need to be replaced because they have the same OUI identifier.

PC2 and PC3 NICs need to be replaced because they have different OUI identifiers.

*PC1 and PC2 NICs are from the same vendor.

PC1 and PC3 NICs need to be replaced because they have the same vendor-assigned address.

*PC2 and PC3 NICs are from different vendors.

PC2 and PC3 NICs are from the same vendor.


Which of the following are considered WAN technologies? (Choose two.)

*DSL

Ethernet

Wireless Ethernet

*T1-Carrier

Token Ring

which one of the router connectors shown in the graphic would be used for a LAN connection?

Connector A

Connector B

*Connector C

Connector D


How is full-duplex capability typically achieved in fiber-optic cable?

*Two fibers are encased in separate sheaths.

Light is bounced at different rates in opposite directions.

Transmit speeds are so high that half-duplex is acceptable.

Colors of the light spectrum are separated into transmit and receive streams.


Which of the following are characteristics of IP? (Choose three.)

connection-oriented protocol

connectionless protocol*

reliable protocol

unreliable protocol *

routed protocol *

routing protocol


Which of the following describe the token-passing logical topology? (Choose two.)

*FDDI is an example of a token-passing network.

Token-passing logical topologies must also be physical ring topologies.

One of the disadvantages of the token-passing logical topology is the high collision rate.

Computers transmit data after "listening" to the wire to detect other traffic.

*Computers are allowed to transmit data only when they possess a token.



What is the maximum length of a media segment used for 100BASE-TX?

*100 meters

185 meters

400 meters

500 meters


which of the following networking devices divide a network into separate collision domains? (Choose two.)

repeater

*bridge

*switch

AUI

hub


Which of the following are characteristics of UTP cable? (Choose three.)

*Each wire is covered by insulating material.

It is not affected by EMI or RFI.

*It is a four-pair wire medium.*

It is difficult to terminate the cable.

*It relies on the cancellation effect produced by the twisted wire pairs.

It is more expensive than any other type of LAN cabling.


Examine the graphic with current configurations. Host A in the Clerical offices failed and was replaced. Although a ping to 127.0.0.1 was successful, the replacement computer can not access the company network. What is the likely cause of the problem?

IP address incorrectly entered

network cables unplugged

*subnet mask incorrectly entered

network card failure


Which of the following describes a physical full-mesh topology?

It requires termination at both ends of the cable.

It uses a hub or a switch as a central point to connect all wires.

*It provides maximum connectivity between all network systems.

It links all computers to a main computer that controls all traffic on the network.


Which two statements describe the TFTP protocol? (Choose two.)

uses authenticated file transfer procedure

provides connection-oriented service

*provides connectionless service

provides more features that FTP

*lacks most of the features of FTP


Which of the following are transport layer protocols of the TCP/IP model? (Choose two.)

FTP
*UDP
SMTP
TFTP
*TCP




Which type of UTP network cable connects two Cisco switches?

straight-through

*crossover

rollover

patch


How will the MAIN router dynamically learn a route to the 10.16.10.48/28 subnetwork in the diagram?

with a routed protocol

with a routing protocol

*with a static route

with a directly connected route


Which of the following describes the RIP version 1 routing protocol?

Cisco proprietary hybrid protocol

*distance vector protocol that uses hop count as the only metric *

link state protocol supporting multiple routed protocols

distance vector protocol that uses delay, bandwidth, load, and reliability metrics


How many broadcast domains are shown in the diagram?

*three

four

five

six

seven

eight



Which of the following are advantages of UTP cable? (Choose three.)

*less expensive than fiber optic

*flexible and easy to run in a building

distance between signal boosts is longer than it is for coaxial

*transmits data at a faster rate than any copper-based media

receives less RMF and EMI interference than other types

Which of the following devices extend a collision domain? (choose 2)
*-hub
*-repeater